Filter
Top Products
VMA5894 and VMA7194 11
Disabling automatic power on
Your monitor is preset at the factory to switch on when you turn
on your vehicle’s ignition. You can set it up to remain off until
you press POWER on the monitor.
1. Press PICTURE several times until you reach the
AUTOPOWER option.
2. Press plus (+) or minus (+) to turn automatic power ON and
OFF.
Returning adjustments to the factory settings
1. Press PICTURE several times to locate the RESET option.
2. Press either minus (-) or plus (+) to reset the settings.
If you don’t wish to reset the settings, either press PICTURE
again or wait for the monitor to exit the picture adjustment
menus automatically.
Note:
If you reset the options and the monitor was set to source 2
(AUX2), the monitor reverts to the default setting of AUX1. If
there is no active video source on AUX1, the screen may go
dark. Press
SOURCE
to switch the monitor back to AUX2.
Using a remote control
The LCD monitor comes with an IR receiver that works with
Clarion remote control devices. Aim the remote control at the
IR receiver during use.
Note:
The IR receiver only functions with select Clarion multime-
dia equipment.
Connecting a video source
The video sources you are using may be preinstalled for you,
or your configuration may be designed to allow you to change
devices.
For example, returning from a day at the beach, you may
disconnect your game from the game port and connect your
camcorder to view the video you just shot.
Caution
Always take care when disconnecting and
connecting electronic devices.