Filter
Top Products
Basic Operations
English
16 DXZ585USB
● Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when the
DZE is set to “DZE OFF”.
2-1. Select “TREBLE”.
2-2. Press the [ ] button.
2-3. Push the [SEEK PANEL] leftward or
rightward and select from:
“T GAIN” ↔ “T FREQ”
3-1. Press the [UP] or [DN] button to adjust the
gain and FREQ (center frequency).
T GAIN: –6 to +6 (The factory default
setting is “0”)
T FREQ: 8KHz/12KHz (The factory default
setting is “12K”)
3-2. Press the [ ] button to return to the
previous mode.
● Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “S RESTOR”.
3-1. Press the [UP] or [DN] button to adjust.
Each time you press the [UP] or [DN]
button, the sound restorer changes in the
following order:
“OFF” ↔ “1” ↔ “2” ↔ “3”
∗ The factory default setting is “OFF”.
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
● Setting high pass filter
2-1. Select “HPF”.
3-1. Press the [UP] or [DN] button to select the
setting. Each time you press the [UP] or
[DN] button, the setting changes in the
following order:
“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”
∗ The factory default setting is “THROUGH”
(through).
● Setting low pass filter
2-1. Select “S-W LPF”.
3-1. Press the [UP] or [DN] button to select the
setting.
Each time you press the [UP] or [DN]
button, the setting changes in the following
order:
“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”
∗ The factory default setting is “THROUGH”
(through).
● Adjusting the balance
2-1. Select “BALANCE”.
3-1. Press the [UP] button to emphasize the
sound from the right speaker, press the
[DN] button to emphasize the sound from
the left speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: L12 to R12)
● Adjusting the fader
2-1. Select “FADER”.
3-1. Press the [UP] button to emphasize the
sound from the front speaker, press the
[DN] button to emphasize the sound from
the rear speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: R12 to F12)