Filter
Top Products
CDi Series Power Amplifiers
Operation Manual
page 17
DESIRED FUNCTION BUTTON PRESSES
(starting from the current preset screen)
Set up Ch. 1 output for 70V/high-Z mode
Sel > Next. Press Sel. The 70V and Ch. 1 icon flash. Press Next to turn on or off. Choose on or
off by pressing Sel.
Set DUAL or BRIDGE-MONO mode manually Sel > Next. Press Sel until the BRG icon flashes. Press Next to set the amplifier to Bridge-
Mono, or press Prev to set the amplifier to Stereo. Press Sel to select your choice.
Select a user preset Sel > Sel. Press Next until you see PRESET 2-20. Press Sel.
Set INPUT Y mode Sel > Next. Press Sel until the Y icon flashes. Press Next to see the three options.
Choose one by pressing Sel.
Turn EQ on or off for Ch. 1 or Ch. 2 Sel > Next. Press Sel until the EQ icon flashes along with CH1 or CH2.
Press Next to set EQ in or out. Press Sel.
Set DELAY for Ch. 1 or Ch. 2 Sel > Next. Press Sel until the DEL icon flashes along with CH1 or CH2.
Press Next until you see the amount of delay you want, then press Sel to select it.
Set LIMITING for Ch. 1 or Ch. 2 Sel > Next. Press Sel until the LIM icon flashes along with CH1 or CH2.
Press Next until you see the limiting threshold you want, then press Sel to select it.
Turn off all the DSP Sel > Sel. Press Next until you see DSP OFF. Press Sel.
Configure a USER PRESET 1. Sel > Sel .
2. Press Next until you see the desired preset. Press Sel to select it.
3. Sel > Next.
4. Press Sel until you see the DSP process you want to apply to that preset.
5. Press Next to see the processing options, then press Sel to select an option.
6. Repeat Steps 1–5 for all the processes you wish to apply to that preset. The CUSTOM ICON
will light if a factory preset has been modified.
* When you call up the XOV process, Ch.1 will always be set to low frequencies and Ch. 2 will
always be set to high frequencies. DO NOT connect high-frequency drivers to Ch. 1.
HOW TO ACCESS PRESETS AND DSP PROCESSES