Directed Video CD1020 Car Video System User Manual


 
IMPORTANT INFORMATION
WHEN CLEANING THE VEHICLE
Do not spray this unit with water or cleaning solutions. Moisture and the chemicals
found in cleaning fluids could damage the consoles finish and interior electronics. A
soft damp, lens cleaning cloth should be used to wipe the screen. Do NOT use any
type of scouring pad, abrasive cleaners, or solvents.
WHILE DRIVING
This unit is intended for use in the rear seat area only. It is illegal in some jurisdictions to
install the unit in a location that would allow the driver to view it while driving.
WHEN PARKED
The screen is easily visible when deployed. Always close the screen when parking for an
extended period of time to avoid potential theft or extended exposure to direct sunlight.
PROPER USE
Do not touch the screen. Do not pull or hang from the fold down monitor door.
REPAIRS
If the monitor stops working for any reason, discontinue use immediately and consult with
your retailer about any necessary repairs.
RADIO/TV TUNER USE
When the unit is used in conjunction with a Radio/TV tuner, please assure that the receiver
is manufactured to receive television broadcast signals that are transmitted via terrestrial
radio waves. Reception quality will change and vary according to vehicle location and
weather conditions.
INSTALLATION
Avoid installing the monitor at a location, where it will be under direct sunlight or a hot air
vent. The operating temperature of the unit is from 32–120°F (0–50°C). Install the unit at
a dry location, where it is away from condensation.
Use only the correct size fasteners and cables during installation. Failure to do so may cause
a mechanical or electrical failure and create a fire hazard. The installation should be done
by an authorized Directed dealer.
NOTE: If the internal temperature of the vehicle is higher than the normal operating tem-
perature, please allow the vehicle to cool down (or warm up if temperature is below
normal operating temperature) prior to operating the unit.
© 2006 Directed Electronics—all rights reserved
7