Filter
Top Products
How to operate the Sound Adjustment Mode
41
X
Making changes with Sound Adjustment Mode
Enters sound adjustment mode.
When the button is turned, the setting item changes in the following order.
Press the [SEL] button to select the setting item. After selecting the setting item, follow
the procedures in the list below.
At this time, other adjustments can also be made in sound adjustment mode.
1
Press the [SOUND] button more than one second.
2
Turn the [SEL] button to select a setting item.
Crossover adjustment (X-Over F/R)
Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off
frequencies: PASS, 80Hz and 100Hz.
Turn the [SEL] button to select the cut-off frequency.
PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
…
Press the [SEL] button.
ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.
Crossover adjustment (X-Over NF)
Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off
frequencies: PASS, 80Hz and 100Hz.
Turn the [SEL] button to select the cut-off frequency.
PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
…
Press the [SEL] button.
ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.
Non-Fader phase selection (Non-F Phase)
The merging of sound between the front and rear speakers and the woofer can be improved by selecting the
phase. Switch to a phase which lets the speakers combine without any disharmony.
Turn the [SEL] button to select the NORMAL or REVERSE.
NORMAL: Normal phase
REVERSE: Reverse phase
Press the [SEL] button.
3
Press the [RTN] button.
4
Press the [SOUND] or [RTN] button to exit sound adjustment mode.
1
2
1
2
1
2