Eclipse - Fujitsu Ten CD8454 Car Stereo System User Manual


 
109
How to operate the Sound Adjustment Mode
ATTENTION
The initial EQ settings are factory preset.
Fine-tuning EQ functions
Fine adjustments can be made in each equalizer mode.
Select the equalizer mode.
Refer to the section "Switching equalizer modes" on page
108.
Turn the [SEL] button to select the frequency to be
adjusted.
When the button is turned, the frequency changes in the
following order.
63Hz
100Hz 160Hz 250Hz 400Hz 630Hz
1kHz 1.6kHz 2.5kHz 4kHz 6.3kHz 10kHz
16kHz
Press the [SEEK /FAST ] button.
This adjusts the frequency level.
[SEEK ] button: Increases level.
[FAST ] button: Decreases level.
Hold down a button, [1] to [5], for more than two
seconds to preset a value.
The preset value is overwritten by the value set using the
above steps.
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
6
5
4
3
2
1
[SOUND] button
[SEL] button
[SEEK ] button
[FAST ] button
[RTN] button
Buttons [1] to [5]
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
5
4