Filter
Top Products
12
Remote control unit
Notes on use
< Point the remote control unit at the amplifier’s remote sensor
within seven meters (23 feet) of the amplifier. There should
not be any obstacles between the amplifier and the remote
control unit.
< Do not allow direct sun or other light to shine on the remote
sensor part of the amplifier. This may cause the remote
control unit to work incorrectly.
< Note that other units with remote controls may operate
incorrectly because of infrared light “overspill” when you
operate this remote control unit.
< To use the remote control unit, set the LINE IN/DIRECT IN
switch on the rear panel to “LINE IN”.
Remote control sensor
The remote control unit RC-1156 is used in common with
Esoteric digital amplifiers and certain CD/DVD players (other than
P-01/D-01).
When configured as an integrated amplifier, you can use the
following buttons for A-100:
VOLUME, INPUT, MUTING
< The remote control unit is available only when the LINE
IN/DIRECT IN switch on the rear panel is set to “LINE IN”.
VOLUME
Use these buttons to adjust the volume.
INPUT
Use these buttons to select an input.
MUTING
Use this button to mute the sound. Note that A, B and C
above only operate in the “LINE IN” (Integrated amp), mode.
C
B
A
A
B
C