Filter
Top Products
U.S.A
.
BBWX2 INSTALLATION GUIDE
Page 9 of 15
Cable Tray
Grommets
Cable Tray
Cover
Cable Tray
Screws
Note: For the power synchronization feature to function, 4 pair Ethernet cables must be used.
See page 6 for a list of cable options.
Connecting Cables to the BBWX2
Each cable type has a corresponding color-coded rubber cable grommet (for water
resistance). The cable grommets are inserted into the enclosure cable tray of the Receiver
unit (as shown below).
The following colors correspond to each type of cable:
The yellow grommet is for the antenna cable
The blue grommet is for the power cable
The red grommets are for the Ethernet cables
The green grommets are for the audio cables
The black grommets (solid) are for when there is no cable
To connect the cables to the BBWX2:
1. Undo the tray cover on the BBWX2 enclosure (three screws on the back).
2. Plug the cable into the appropriate connector.
3. Install the corresponding cable grommet in the enclosure cable tray
4. Press the cable into the slot in the grommet. Make sure it is seated well with minimal
strain.
5. Repeat for all cables to be installed.
6. Insert black grommets (with no cable hole) into slots
with no cables.
7. Place the tray cover back on the unit and tighten
screws.
Note: If the unit was already mounted, loosen mounting screws, lift and remove unit to
access tray cover for a cable change.