Filter
Top Products
12
www.insignia-products.com
Replacing the remote control battery
If the remote control does not function, or if the
operating range becomes reduced, replace the
old battery with new one.
To replace the battery:
1 Slide the battery holder to the right (as
shown) while at the same time pulling it away
from the remote control.
2 Remove the old battery, then place the new
lithium battery with the (+) side up in the
battery holder. (Use battery type CRD2025.)
3 Slide the battery holder back into the remote
control until it clicks into place.
Troubleshooting
Note
• Dispose of the used battery correctly.
• Do not misuse the battery by shorting the
positive + and - negative terminal or putting it
into fire which may cause the battery to
explode.
• The battery and battery holder can be a
choking hazard. Keep the remote control away
from young children.
Problem Cause Solution
The player suddenly
stopped working or
the screen went
black.
Player error. Try turning the
player off and on. If
the player still
doesn’t respond,
press the reset
button.
Player doesn’t turn
on.
The car ignition (or
ACC/Accessory) is
off.
Insert the key into
the ignition and turn
it to ACC/Accessory.
Condensation in the
player.
Wait for about one
hour or until
condensation
evaporates.
Player operates
erratically.
Remote control
battery needs
replacing.
Replace the battery.
Dirty IR window on
the player or remote
control.
Clean the player’s
and the remote
control’s IR
windows.
Loose connections. Check and tighten all
connections.
Player does not play
disc.
Disc is inserted
incorrectly.
Reinsert the disc
with the label side up
(facing the ceiling).
Disc is dirty or
scratched.
Clean or replace the
disc.
Disc format is not
supported.
Check the disc
format.
Regional code of DVD
doesn’t match the
player’s regional code
(Region 1).
Insert a Region 1
DVD.
Picture skips
occasionally.
Disc is dirty or
scratched.
Clean or replace the
disc.
Picture is blurry. Interference. Move the vehicle
away from the
interference.
Picture is too dark. The player is too
cold.
Wait for a few
minutes until the
player warms up.
Brightness is set too
low.
Adjust the
brightness setting.
No sound from
headphones.
Wireless headphones
are not turned on.
Turn on the
headphones.
Headphone batteries
are too low.
Replace or recharge
the batteries.
An object is blocking
the line of sight
between the IR
headphones and the
IR window on the
player, or the
headphones are too
far away from the
player.
Remove the
obstruction or move
closer to the
transmitter.
NS-M10OHD_FINAL4.fm Page 12 Wednesday, March 29, 2006 4:12 PM