Filter
Top Products
5. Installation
1. When making electrical connections it is always recommended that the vehicle’s
battery be disconnected from the electrical system before performing the
installation.
Please Note: Some Hondas require a security code be
input into the radio once power is disconnected. Please
make sure you have this code available before proceeding
with the installation. If the radio is equipped with a built in
CD Changer, please remove ALL discs before proceeding
to prevent damage to the radio’s CD mechanism.
2. Carefully remove the trim panels covering the 8mm bolts that secure the radio into
the dash cavity. Remove these bolts, and carefully pull the radio from the dash of
the vehicle. This will provide access to the factory radio connectors where you will
connect the Media Gateway harness.
3. Disconnect the factory 14-Pin harness (if present) from the back of the radio.
4. Connect the 8-Pin iPod docking cable into the rst port on the Media Gateway
(farthest away from dipswitches). If you are also installing the ISBT21, the iPod
cable should be connected to the second port (farthest from the dipswitches).
Carefully run the 11 foot iPod cable behind the dash to the location where the iPod
will be mounted or stored (for example the glove box or center console). This
location will vary based on the vehicle, and the customer’s preference. When
running this cable through the dash be sure to secure it away from moving parts or
sharp metal edges that may damage the cable.
5. Connect the 8-Pin auxiliary input cable to the second port (closest to the
dipswitches) on the Media Gateway if an additional auxiliary input is desired.
Steps 6, 7 & 8 apply to Satellite Radio Emulation Mode
ONLY
6. If connecting the HD Radio Tuner (HDRT sold separartely), make the folllowing
connections before connecting the PXAMG to the vehichle. Plug the 3 foot HD
Radio Cable (8-Pin mini-din to 8-Pin mini-din) cable into the second port (closest to
the dipswitches) on the Media Gateway. Connect the other end of this cable into
the HD Radio tuner. Connect the factory antenna cable into the antenna
connection on the HD Radio tuner (HDRT).
7. If connecting the Satellite Radio tuner (SCC1 sold separartely), make the folllowing
connections before connecting the PXAMG to the vehicle. Plug the black end
of the 3 foot ISSR11 (8-Pin mini-din to 8-Pin mini-din; sold seperately) into the
second port (closest to the dipswitches) on the Media Gateway. If you are installing
the Satellite Radio Tuner with the HDRT, connect the ISSR11 cable to the port
farthest from the dipswitches. Connect the gray end of this cable into the Satellite
Radio tuner.
4