iSimple PGHHD1 Car Satellite Radio System User Manual


 
8. If connecting the ISBT21 (sold separartely), make the folllowing
connections before connecting the PXAMG to the vehichle. Plug the 3 foot
ISBT21 Cable (8-Pin mini-din to 8-Pin mini-din) cable into the rst port (farthest
from the dipswitches) on the Media Gateway. Connect the other end of this cable
into the ISBT21. Connect the microphone cable into the 3.5 mm
connection on the ISBT21.
9. Plug the male connector on the PGHHD1 harness into the 14-pin port on the back
of the radio. Next, connect the factory 14-pin harness (if present) into the female
connector on the PGHHD1 harness. Be sure to make a rm connection but do not
force it. Plug the Black micro-t 24-pin connector on the PGHHD1 harness into the
PXAMG Media Gateway box.
10. To complete the installation secure the Media Gateway (PXAMG) and HD Radio
tuner (HDRT if equipped) or SCC1 (if equipped) into the cavity in the dash behind
the radio. Be sure that the cables and interface modules are not near moving parts
or sharp metal edges as they may damage the cables. To prevent rattling noises
inside the dash, use zip ties, tape, or other fasteners to mount the interfaces
securely.
11. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the Media Gateway
and HD Radio tuner before reinstalling the factory dash panels.
12. Note: The rst time you access the Gateway in satellite emulation mode, your
radio may display “DEV INIT” while the device is initializing. If this is displayed,
please wait one minute then cycle the ignition off and on. Then access SAT mode
again to begin normal gateway operation.
A. Satellite Radio Emulation
This mode of emulation can only be used in vehicles that have an “XM” or
“SAT” button on the face of the radio.
PLEASE NOTE: It is very important that you keep the text display in the eld
labeled “Channel Name”. This will give you the most user friendly Media
Gateway experience.
1. iPod Operation
Entering Mode Select Menu
Press the “AM-FM” button then press the “XM” button. IMMEDIATELY turn the
rotary TUNE KNOB or press “TUNE ▲” until “IPOD” is displayed. The PXAMG will
auto select the mode after 6 seconds of inactivity.
5