Filter
Top Products
2-4 Controls and operation
Source tone memory
Bass and Treble positions are
automatically memorised for AM radio,
FM radio, cassette tape and CD/MD,
allowing individual settings for each
mode.
Change audio system source
Press the desired audio system source
button.
Band Switch AM/FM
Pressing AM/FM repeatedly will cycle the
radio through FM. Band selection will be
shown in the display panel. When a tape
or CD/MD is being played, pressing the
band switch will select radio operation.
Presetting memorised radio stations
!
WARNING:
In the interests of road safety, do not
attempt to preset a station while
driving.
On each waveband, nine stations can be
memorised using keypad buttons 1 to 9.
After tuning to a station, press and hold
the selected button until the unit ‘beeps’.
A station can be recalled from the preset
memory by pressing and immediately
releasing the button. Pressing the steering
wheel preset selector button will cycle
through the preset stations.
Seek and manual tuning
In AM/FM mode, pressing and releasing
the left or right button will activate the
radio in seek mode, tuning through the
frequency range to the next available
station. Pressing either button for more
than two seconds will enter manual
tuning mode.
Auto memory (A MEM)
The automatic memory function
programmes the nine strongest stations
on a selected waveband to presets 1 to 9.
Note: These are additional to the preset
stations described earlier.
To activate this function, press and hold
AMEMbutton for at least two seconds.
The radio will be briefly muted while it
searches the waveband for the nine
strongest stations. When programming is
complete the radio will default to preset
number 1 and audio volume is restored.