Filter
Top Products
Controls and operation 2-13
Radio set up
This function enables the radio to be set to user operating
preferences. By selecting SET UP and using the preset buttons,
the owner or Jaguar Dealer can adjust certain radio functions.
When in SET UP, pressing the relevant preset button, as
detailed below, will display the facility selected and its state.
The state of that facility can be changed by pressing the preset
button again.
To enter SET UP: Press Tape Eject and AM/FM buttons
simultaneously.
The display will show SET UP. The following preferences can
then be selected or changed in any order, within a 15 second
period. After 15 seconds the display will clear and exit SET UP.
Preset 1 Press Preset 1 to enable or disable RBDS,
depending upon RBDS availability in the user’s
country.
Preset 2 On cassette tape models, this controls the
Tape Clean reminder facility. To switch off this
reminder, press the Preset 2 button until
TAPE CLN OFF shows on the display.
Preset 3 Blank.
Preset 4 Blank.
Preset 5 KEY OFF EJECT – On cassette tape models,
this sets the cassette tape to automatically eject
when the ignition key is turned to 0.
Preset 6 Blank.
Preset 7 Blank.
Preset 8 Blank.
Preset 9 Blank.
Preset 0 During initial factory installation, this is used to set
the radio to the USA region. Regional settings
determine the correct frequency increments
required for seeking stations, automatic tuning etc.
Note: The regions are preset at the factory.
Should you require a regional change, consult your
Jaguar Dealer.