Filter
Top Products
CD1211
11
Repeat for the remaining five presets on the
current band and for all presets on the other
three bands.
Automatically Store / Preset
Scan (AS/PS)
Automatically Store
Select six strong stations and store them in the
current band using the Automatic Store feature.
To enable this feature, press and hold AS/PS
(17) for more than two seconds. The radio will
automatically scan the band in use and enter
strong stations into the preset memory
positions for that band. After entering the
stations into memory, the unit will automatically
stop at each station for five seconds so each
can be heard. When using the Automatically
Store feature, the new stations replace any
stations already stored in preset memory for the
selected band.
Preset Scan
Press AS/PS (17) to scan the six preset
stations in the AM band or all FM bands . The
unit will stop at each station for five seconds
before continuing to the next preset station, and
the preset number will flash on the display
during the preset scan. Press AS/PS again to
stop scanning and listen to the current station.
Mono/Stereo Selector (MONO)
Press MONO (18) during FM radio operation to
select stereo reception of the broadcast signal.
Under normal reception, the unit should be left
in the stereo mode as indicated by the “ST”
designation and the associated signal strength
indicator that appear on the display panel when
tuned to an FM stereo signal. If the signal is too
noisy for comfortable listening, press MONO to
switch to mono reception. The “ST” indication
will disappear. Press MONO again to return to
stereo mode.
Local / Distance Selector
This feature is used to designate the strength of
the signals at which the radio will stop during
automatic tuning. Distant, or “Dx” is the default
setting, allowing the radio to stop at a broader
range of signals. To set the unit to select only
strong local stations during automatic tuning,
press the LOC button on the remote control.
“LOCAL” appears in the display.