Jensen CD1211 Car Stereo System User Manual


 
CD1211
9
Display (D)
When the unit is off, the LCD displays the time
of day. When the unit is on, the LCD
automatically shows the tuner or CD display,
depending on which mode of operation is
currently activated.
Display Clock
During tuner or CD operation, press D (9) to
display the time of day. After five seconds, the
display reverts to tuner or CD display.
Set Clock
1. To set the clock, turn the radio on in tuner
mode (or any other mode).
2. Press D. The time appears on the display.
3. Press and hold D until the time display
begins flashing.
4. While the display is flashing, press the Up
Tuning button (14) to adjust hours and the
“A” (AM) or “P” (PM) indication. Press the
Down Tuning button (13) to adjust
minutes.
5. After five seconds, the time will set and the
display will return to tuner or CD display.
Auxiliary Input
Use the Aux In connector (19) to connect a
portable media device for playback through the
vehicle sound system.
Front Panel Release
The front panel release button (10) releases the
mechanism that holds the front panel to the
chassis.
Detaching the Front Panel
To detach the front panel, first press the front
panel release button (10) to release the left side
of the panel. Next, grasp the released side and
pull it off the chassis. After removing the front
panel, store it in the supplied carrying case to
protect it from dirt and damage.
Re-attaching the Front Panel
To re-attach the front panel, make sure the
electrical terminals on the back of the panel are
free of dust and dirt, as debris could cause
intermittent operation or other malfunctions.
Position the right side of the panel in place so
that it is correctly engaged, then lightly press
the left side of the panel until the mechanism
locks it into place.
Reset Button
The reset button (11) is located on the front of
the chassis and can only be accessed with the
front panel removed. The reset circuitry
protects the microprocessor circuitry. Since
resetting the unit will erase the time and preset
memories, it should only be activated upon
initial installation after all wiring is complete, or
if there is a malfunction of any of the switches
on the unit. In these circumstances, pressing
the reset button will clear the system and return
the unit to normal operation.
Theft Deterrent LED
A light-emitting diode (LED) (12) is located on
the chassis behind the front panel and will flash
when the panel is removed. The flashing light
serves as a visual warning to the would-be thief
that the unit has been disabled by removal of
the front panel.
1
2
/
T
U
N
E
CD1211 CD RECEIVER
S
C
A
N
M
O
N
O
E
Q
A
U
X
IN
REMOVE FRONT PANEL
RESET
12 11