Filter
Top Products
Installing the GPS antenna, Fig. 7
The GPS antenna may be installed in the passenger compartment, for example on the
dashboard or the rear shelf. The antenna needs to have unrestricted “visual contact”
to the sky.
–
Clean the mounting surface and attach the antenna with the double-sided adhesive
tape.
–
Vehicles with metallized windows should have the antenna installed on the trunk
lid, on the roof or in the plastic bumper.
Note: To guarantee the functioning of the antenna, maintain a minimum distance of
4 inches to any metal parts (window frame, etc.) during installation.
Install installation bracket, Fig. 8 - 10
The navigation radio can be installed into a vehicle’s DIN radio slot using the installation
bracket provided.
■
Note before installing, Fig. 13:
–
The radio must be installed horizontally. Deviations of -10 to +30 degrees can be set
in the “Mounting angle” menu (see “Initial operation”). Larger deviations may
result in malfunctions.
–
A rigid connection to the vehicle body is a prerequisite for correct functioning of
the system
Insert the installation bracket into the DIN slot and bend the appropriate metal tabs
inwards using a screwdriver. Take care not to damage any hidden parts in the
dashboard.
Mounting the radio, Fig. 11
1. Connect the GPS antenna connector to the GPS antenna socket on the back of the
unit.
2. Insert antenna plug E into antenna socket. If necessary, use a suitable antenna adapter.
Use a backstrap on the rear of the unit for secure attachment.
3. Insert ISO plug A (power supply) into the radio ISO socket A.
4. Insert ISO plug B (loudspeakers) into the radio ISO socket B.
If extensions are to be connected to the unit (optional):
5. Remove the dust cover from ISO socket C.
6. Push all C connectors together and plug them into the radio ISO socket "C".
Push the green connector C2 between the yellow connector C1 and the blue
connector C3. At least one of these connectors is required for C2 to engage into the
socket.
Yellow plug C1: Left chamber of ISO socket C1.
Green connector C2: Center chamber of ISO socket C2.
Blue connector C3: Right chamber of ISO socket C3.
7. Push the unit into the mounting frame until it engages.
Note: Always securely install the radio before connecting to the power supply.
Otherwise the gyro sensor may be calibrated incorrectly.
INSTALLATION INSTRUCTIONS
6