Filter
Top Products
Continued on Next Page
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
STEP 7
Remove the plastic cover from the upper d-pillar trim.
Remove the phillip head screw that has been exposed .
STEP 6
Remove the top sill plate.
STEP 5
Remove the lower d-pillar trim.
STEP 4
Remove the bottom sill plate.
Page 2 • JL Audio, Inc 2007
STEP 9
With a T-30 socket, remove the bolt and metal bracket that
is located between the two rear seats.
STEP 11
Flip the driver’s side rear bottom cushion towards the front
of the vehicle.
STEP 10
Grab a hold of the back of the driver’s side rear seat as in
the picture.
Lift the right side of the seat up and out of the hinge
bracket.
Pull the left side of the seat towards the middle of the
vehicle, sliding the seat off of a hinge pin.
Once the seat is off both hinge points, remove the seat
from the vehicle.
STEP 8
Remove the upper d-pillar trim.