Filter
Top Products
Continued on Next Page
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
STEP 15
Remove the plastic ring from the rear seat’s upper latch pin.
STEP 14
With a 17mm socket and ratchet, remove the seat belt
retracting unit.
STEP 13
Remove the trim panel.
STEP 12
Remove the plastic collar that is around the hinge pin.
Page 3 • JL Audio, Inc 2007
STEP 17
An airbag is located behind the c-pillar trim. Use caution
while removing this panel. All wiring/connections should be
protected.
As in the illustration, reach around to the rear of the c-pillar
trim and carefully remove the c-pillar trim from the c-pillar,
by pulling towards you.
STEP 19
From the driver’s side rear door opening. Pull the front of the
cargo side trim panel from the vehicle’s body. Do not fully
remove this side trim panel at this time.
STEP 18
With a T-25 socket remove the bolt that secures the front
of the side trim panel to the c-pillar.
STEP 16
Pull the SRS plastic badge from the upper c-pillar trim.
With a T-25 socket, remove the bolt that has been
exposed.