Filter
Top Products
Continued on Next Page
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231
STEP 23
With a T-30 socket, remove the bolts that secure the pocket
to the body of the vehicle.
STEP 22
Pull the side trim panel out of vehicle.
STEP 21
Pull the rest of the side trim panel from the body of the
vehicle.
Once the side trim panel is loose, disconnect the power
outlet 12V plug from the wire harness.
STEP 20
With a T-25 socket, remove three bolts that secures this
rear side trim panel.
Page 4 • JL Audio, Inc 2007
STEP 25
Place the supplied top mount plate into position. The plate
will only fit one way. The hole in the mounting plate will line
up with the access hole from the removed grommet.
STEP 27
Thread in one of the supplied socket cup set screws into the
bottom of the Stealthbox®, leaving 1-inch exposed.
STEP 26
Run speaker wire from the amplifier’s location to the
Stealthbox
®
location and check for proper operation of
the woofer.
STEP 24
Found in the rearmost driver’s side floor corner, remove
the rubber grommet in the cargo area.
Unsecure the wire harness from the wheel well.
*Make sure the ignition is not turned on*
Loosen the bolt that secures the brown wires to the
flooring of the vehicle.
Once loose, turn this wire assembly counter clockwise until
the wires are routed as illustrated in the picture. Secure the
bolt.