Filter
Top Products
SLPK-CAN-SPYDER1_INSTR_SKU# 011312
Page 4• JL Audio, Inc 2009
S T E P 2 1
Drill the holes as marked through the fairing, each hole
needs to be 5/16” in diameter.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a
reduction in your weekly pay.
Always wear eye protection when drilling!
S T E P 2 3
Run the speaker wire through the bottom hole drilled in
STEP 21 as shown.
S T E P 2 2
Looking through the gauge cluster location, install the “U-
Bolt” around the steel dash structure and through the two
upper holes drilled in
STEP 21.
S T E P 2 0
alignment of the front of each pod, once both front and rear
alignment is achieved, use a marker to make marks on the
masking tape shown in
STEP 17 through the holes in the
pods identified in STEP 18.
If you are ONLY installing the pods and NOT the full system,
You have completed your installation of the pods.
Run the wire from either side of the fairing to your source (or amplifier) location.
Enjoy your new Slampak®!
S T E P 2 6
Under the seat, directly above the fuse panel, you’ll notice a
grounding point, this is an excellent location to get a good
ground for the amplifier, secure the ring terminal for the
ground to this point. Run the ground cable so that it can
integrate into the Split Loom with the positive battery cable.
Again,
Make sure on all cabling runs to secure all wires when
running them so that they cannot get tangled in any
moving parts or the exhaust system.
S T E P 2 5
Locate the battery above the rear tire, disconnect the
negative battery terminal. Secure the fuse holder close to
the terminal, remove the fuse. Attach the ring terminal for
the positive battery run to the positive battery terminal and
run the cable from the battery terminal to the fuse holder.
Attach the cable to the fuse holder. Attach the remaining
cable to the output of the fuse holder and run it through the
included Split Loom.
Make sure on all cabling runs to secure all wires when
running them so that they cannot get tangled in any
moving parts or the exhaust system.
S T E P 2 4
Set each pod into position, with the “U-Bolt” coming
through the two upper holes and the wire coming through
the bottom hole. Secure the pod to the motorcycle using
the included 1/4 x 1” Fender Washer and 1/4” Nyloc Nut on
each leg of the “U-Bolt”, tighten using a rotation method
similar to changing a tire so that both legs are tightened
simultaneously.
Hook up the wire to the speaker and, re-install speakers into
pods.