Filter
Top Products
Getting Started
• Before you can operate the remote control, you must first
install the batteries (included). See “Changing the
Batteries”at the bottom of this page for instructions. (For
an illustration, please see page 8.)
• Press the POWER button to turn the television on or off.
• Make sure the “TV/CATV” switch is set to “TV.” Move the
switch to “CATV”only if you need to operate a cable box.
• Slide the “VCR/DVD” selector switch to “VCR”to control a
VCR. Slide to “DVD” to control a DVD player. Please see
pages 19 to 21 for instructions on programming your
remote control to operate a Cable Box, VCRor DVDplayer.
• Press the CH+ and CH– buttons to scan through the chan-
nels. Tap the CH+ or CH– button to move through the
channels one channel at a time.
• To move rapidly through the channels using JVC’s
Hyperscan feature, press and hold CH+ or CH–. The chan-
nels will zip by at a rate of five channels per second.
• Press VOL+ or VOL– to raise or lower the volume. An indi-
cator bar will appear onscreen to show you the television
volume level.
• The CH+/– and VOL+/– buttons are also used to navigate
JVC’s onscreen menu system.
• You can directly access specific channels using the 10-key
pad.
For more information on remote control button features, see
pages 43 – 47. For information on using the onscreen
menus, see page 22.
Changing the Batteries
Push down on the remote’s back cover and slide towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the "+" and "–" markings on the batteries
and on the remote control. To avoid a potential short circuit, insert the "–" end first. Be sure to
use only size AA batteries. When batteries are installed, slide the cover back into place (until it
clicks into position).
NOTE:
• If the remote control acts erratically, replace the batteries. Typical battery life is six months to
one year. We recommend using alkaline batteries for longer battery life. When you change
the batteries, try to complete the task within three minutes. If you take longer than three min-
utes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset.
(See pages 19-21.)
Remote Control Basics
18
AV-36P902 English 9/13/01 3:55 PM Page 18