Filter
Top Products
20
ENGLISH
To select the scroll mode — SCROLL MODE
You can select the scroll mode for the disc
information if it consists of more than 12
characters. When shipped from the factory, Auto
Scroll mode is set to “SCROLL ONCE.”
• SCROLL ONCE:Scrolls only once.
• SCROLL AUTO: Repeats the scroll
(in 5-second intervals).
• SCROLL OFF: Cancels Auto Scroll.
Note:
Even if the scroll mode is set to “SCROLL OFF,” you
can scroll the display by pressing DISP for more than
1 second.
To select the subwoofer cutoff frequency
— WOOFER FREQ
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer. When shipped from the factory,
the subwoofer cutoff frequency is set to “FREQ
MID.”
• FREQ LOW: Frequencies higher than
50 Hz are cut off to the
subwoofer.
• FREQ MID: Frequencies higher than
80 Hz are cut off to the
subwoofer.
• FREQ HIGH: Frequencies higher than
120 Hz are cut off to the
subwoofer.
To change the AM/FM channel intervals
— AREA CHANGE
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and
200 kHz for FM (AREA US settings).
You will have to change the channel intervals
when using this unit in an area other than North
America and South America.
• AREA EU: Select this when using this
unit in an area other than
North and South America.
(9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for
searching) for FM)
• AREA US: Select this when using this
unit in North or South
America. (10 kHz for AM and
200 kHz for FM)
Note:
If the channel intervals settings are changed, the
following will occur.
• The names assigned to the stations will be erased
from memory. To reassign the names, see
“Assigning names to the sources” on pages
23 – 24.
To adjust the line input level — LINE ADJ
Adjust the line input level properly when an
external component is connected to the LINE IN
plugs. When shipped from the factory, the line
input level is set at level “00.”
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change from the external component to another
source.
EN17-24.KD-LX300[J]f 1/5/01, 3:39 PM20