Filter
Top Products
21
ENGLISH
To make the front panel look flat (hiding
the control panel) — FLAT PANEL
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected.
• FLAT ON: The control panel will not
come out when you turn on
the unit.
To use the control panel,
press 4 so that the
control panel comes out. If no
operation is done for about
10 seconds, it automatically
goes back into the receiver.
• FLAT OFF: You can use the control panel
normally.
Note:
When “FLAT ON” is selected, you can eject a CD by
holding 4 .
To turn the demo mode on or off
— DEMO MODE
You can turn the demo mode on or off. When
shipped from the factory, “DEMO ON” is
selected.
• DEMO ON: Turns the demo mode on.
The demonstration will start
automatically if no sound
comes in for 3 minutes.
• DEMO OFF: Turns the demo mode off.
Note:
If the unit has been reset (and the power is on),
demonstration will start if no sound comes in for
about 10 seconds.
Controlling the volume
automatically (Audio Cruise)
You can select the proper cruise mode for your
car.
This unit changes the volume level automatically
(at 3 possible levels) based on the driving speed
of your car by detecting the alternator’s
generating frequency (Audio Cruise).
If you want to use this mode, follow the
procedure below. When shipped from the factory,
this mode is set to “CRUISE OFF.”
• CRUISE 1: Select this if your car is
relatively quiet.
• CRUISE 2: Select this if your car is
relatively loud.
The volume increase rate is
twice as much as that of the
CRUISE 1 setting.
• CRUISE OFF: Cancels Audio Cruise.
1
Press and hold SEL (Select) for
more than 2 seconds so that one of
the PSM items appears on the
display. (See page 18.)
2
Select “CRUISE MODE.”
3
Select the desired setting.
As you turn the control dial, the Audio
Cruise mode changes as follows:
CRUISE 1
CRUISE 2
CRUISE OFF
CONTINUED ON NEXT PAGE
EN17-24.KD-LX300[J]f 1/17/01, 9:20 AM21