Filter
Top Products
29
ENGLISH
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press EQ to activate the sound mode
(EQ).
Each time you press the
button, the sound mode (EQ)
is activated or deactivated.
• When the sound mode (EQ)
is activated, the last selected
sound mode is recalled and
applied to the current source.
2
Select the sound mode you want.
3
Press SEL (select) to enter adjustment
mode.
Ex.: When you have selected “POP” previously
The last adjusted frequency and its level appear
on the display.
4
Select the frequency.
• You can select 70 Hz,
150 Hz, 400 Hz,
1 kHz, 2.4 kHz, 6 kHz
and 12.5 kHz.
5
Adjust the level of the selected
frequency in the step above.
• You can adjust the
level within the range
of “–05” (minimum) to
“+05” (maximum) for
each frequency.
6
Repeat steps 4 and 5 to adjust the
other frequency levels.
7
Select one of the user sound modes
(USER 1, USER 2, USER 3).
8
Press SEL (select) to store the
adjustments.
Note:
If you want to make temporary adjustments and not
store in memory, skip steps 7 and 8. Your temporary
adjustments will remain effective until you select
another sound mode.
Ex.: When you select “USER 2”
EN27-29SH909_707[J]f.pm5 17/1/02, 11:32 AM29