Filter
Top Products
27
ENGLISH
• AREA EU: Select this when using this unit in
an area other than North and
South America. (9 kHz for AM and
50 kHz (for manual tuning) /
100 kHz (for searching) for FM)
• AREA US: Select this when using this unit in
North or South America. (10 kHz
for AM and 200 kHz for FM)
Note:
If the channel intervals settings are changed, the names
assigned to the stations will be erased from memory. To
reassign the names, see “Assigning names to the
sources” on pages 28.
To adjust the line input level – LINE ADJ
Adjust the line input level properly when an
external component is connected to the LINE IN
plugs.
When shipped from the factory, the line input level
is set at level 00.
If the input level of the connected component is
not high enough, increase the input level properly.
Without adjusting the line input level, you may be
surprised at a loud sound when you change the
source from the external component to another
source.
To adjust the auxiliary input level
– AUX ADJ
Adjust the auxiliary input level properly when an
external component is connected to the MP3 INPUT
jack.
When shipped from the factory, the auxiliary input
level is set at level 00.
If the input level of the connected component is
not high enough, increase the input level properly.
Without adjusting the line input level, you may be
surprised at a loud sound when you change the
source from the external component to another
source.
To select the target component to operate
through this receiver – KEY SELECT
You can operate either JVC’s DVD player or VCR
through this receiver, by using the number buttons
on the control panel.
When shipped from the factory, these number
buttons are set to be used for the DVD operations.
To use these number buttons on the control panel
for DVD or VCR operations, see page 32.
To change the FM tuner selectivity
– IF FILTER
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard. This unit has been preset to
automatically reduce this interference noise
(“AUTO”) when shipped from the factory.
• AUTO: When this type of interference occurs,
this unit automatically increases the
tuner selectivity so that interference
noise will be reduced. (But the stereo
effect will also be lost.)
• WIDE: Subject to the interference from
adjacent stations, but sound quality
will not be degraded and the stereo
effect will not be lost.
To turn the demo mode on or off – DEMO MODE
You can turn the demo mode on or off.
When shipped from the factory, “DEMO ON” is
selected.
• DEMO ON: Turns the demo mode on. The
demonstration will start
automatically if no sound comes
in for 3 minutes.
• DEMO OFF: Turns the demo mode off.
Note:
If the unit has been reset (and the power is on),
demonstration will start if no sound comes in for about
10 seconds.
To turn the tag display on or off – TAG DISP
An MP3 file can contain file information called “ID3
Tag” where its album name, performer, track title,
etc. are recorded.
There are two versions–ID3v1 (ID3 Tag version 1)
and ID3v2 (ID3 Tag version 2). This unit is
compatible only with ID3v1.
When shipped from the factory, “TAG ON” is
selected.
• TAG ON: Turns on the ID3 tag display while
playing MP3 files.
* If an MP3 file does not have ID3 tags,
directory and file name appear.
Note:
If you change the setting from “TAG
OFF” to “TAG ON” while playing an
MP3 file, the tag display will be
activated when the next file starts
playing.
• TAG OFF: Turns off the ID3 tag display while
playing MP3 files. (Only the directory
name and file name can be shown.)
EN24-30.KD-SH99[J]f 4/3/01, 3:45 PM27