Filter
Top Products
ENGLISH
29
Using a subwoofer
By connecting a subwoofer to the SUBWOOFER
OUT plugs on the rear, you can enjoy enhanced
bass sounds and a more realistic theater
atmosphere in your car.
• Refer also to the instructions supplied with your
subwoofer.
When a subwoofer is connected to this unit, select
an appropriate cutoff frequency level for your
subwoofer. When shipped from the factory, the
subwoofer cutoff frequency is set to “MID”.
To set the subwoofer cutoff frequency, follow
the procedure below.
• See also “Changing the general settings (PSM)”
on page 21.
• LOW: Frequencies higher than 50 Hz are cut
off to the subwoofer.
• MID: Frequencies higher than 80 Hz are cut
off to the subwoofer.
• HIGH: Frequencies higher than 120 Hz are cut
off to the subwoofer.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press ¢ or 4 repeatedly until
“CUTOFF F” (frequency) appears on the display.
3 Press + or – to select the desired cutoff frequency.
4 Press SEL (select) again to finish the setting.
To adjust the subwoofer output volume, see
“Adjusting the sound” on page 18.
EXTERNAL COMPONENT OPERATIONS
Playing an external component
When connecting an external component to the
LINE IN plugs on the rear, you can select the
component as the sound source.
1
Select the external component (EXT–
LINE IN).
Each time you press the
button, the source changes
as described on page 6.
2
Operate the external component.
Note:
For the external component connection, see the
Installation/Connection Manual (separate volume.)
EN29-33.KS-LX200R[E]f 8/30/00, 10:10 AM29