Filter
Top Products
7
Notes:
• If you release your finger from the button, the
manual search will automatically turn off after
5 seconds.
• If you hold down the button, the frequency keeps
changing (in 50 kHz intervals for FM and 9 kHz for
AM) until you release the button.
Storing stations in memory
You can use one of the following methods to store
broadcasting stations in memory.
• Automatic preset: SSM (Strong-station
Sequential Memory)
• Manual preset
Automatic preset: SSM
You can preset up to 6 local stations in each FM
band (FM1, FM2, and FM3).
1
Select the band (FM1, FM2, or FM3).
2
Press MONO/SSM for more than 1
second.
“SSM” appears, then disappears when
automatic preset is over.
Local stations with the strongest signals are
searched for and stored automatically in the
band you have selected (FM1, FM2, and FM3).
These stations are preset in the number
buttons—No. 1 (lowest frequency) to No. 6
(highest frequency).
When automatic preset is over, the station stored
in the number 1 button will be automatically
tuned in.
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing an FM station of 92.5 MHz into the
preset channel number 1 of the FM1 band
1
Select the FM1 band.
2
Tune in to a station (in this example,
of 92.5 MHz).
To tune in to stations of higher
frequencies
To tune in to stations of lower
frequencies
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
Preset number flashes for a while.
CONTINUED ON THE NEXT PAGE
ENGLISH