Filter
Top Products
ENGLISH
24
Category Menu items Selectable settings, [reference page]
AUDIO
FADER*
5
Fader
FADER R12
— FADER F12:
Adjust the front and rear speaker output balance.
[Initial: 00]
BALANCE *
6
Balance
BALANCE L12
— BALANCE R12:
Adjust the left and right speaker output balance.
[Initial: 00]
VOL ADJUST
Volume adjust
VOL ADJ –10
— VOL ADJ +10:
[Initial: VOL ADJ 00]
Preset the volume adjustment level of each source (except
FM, BT PHONE and BT AUDIO), compared to the FM volume
level. The volume level will automatically increase or
decrease when you change the source.
• Before making an adjustment, select the source you want
to adjust.
• “VOL ADJ FIX” appears on the display if “FM”, “BT PHONE”,
or “BT AUDIO” is selected as the source.
SUB.W FREQ
Subwoofer cutoff
frequency
• LOW:
• MID:
• HIGH :
Frequencies lower than 72 Hz are sent to the subwoofer.
Frequencies lower than 111 Hz are sent to the subwoofer.
Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W LEVEL
Subwoofer level
SUB.W 00
— SUB.W 08:
Adjust the subwoofer output level.
[Initial: SUB.W 04]
BEEP
Keypress tone
• BEEP OFF:
• BEEP ON:
Deactivates the keypress tone.
Activates the keypress tone.
AMP GAIN
Amplifier gain
control
• LOW POWER:
• HIGH POWER:
• OFF:
VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
VOLUME 00 – VOLUME 50
Deactivates the built-in amplifier.
If you change the “AMP GAIN” setting from “HIGH POWER” to “LOW
POWER” while the volume level is set higher than “VOLUME 30,” the unit
automatically changes the volume level to “VOLUME 30.”
SELECT SRC
AM *
7
AM station
• AM OFF:
• AM ON:
Disable “AM” in source selection.
Enable “AM” in source selection.
EXT IN *
8,
*
9
External input
• EXT OFF:
• EXT ON:
Disable “EXT INPUT” in source selection.
Enable “EXT INPUT” in source selection.
AUX IN *
10
Auxiliary input
• AUX OFF:
• AUX ON:
Disable “AUX IN” in source selection.
Enable “AUX IN” in source selection.
*
5
If you are using a two-speaker system, set the fader level to “00.”
*
6
This adjustment will not a ect the subwoofer output.
*
7
Displayed only when any source other than “AM” is selected.
*
8
Displayed only when any source other than “EXT INPUT” is selected.
*
9
Not required for SIRIUS/XM tuners and Bluetooth.
*
10
Displayed only when any source other than “AUX IN” is selected.
KD-HDR40[J].indb 24KD-HDR40[J].indb 24 09.11.10 3:41:27 PM09.11.10 3:41:27 PM