Filter
Top Products
Electronic programme guide and applications
11
Receiver operation
In this chapter, you learn how to select both TV and radio programmes using your
receiver, how to adjust the volume and how to programme the timer functions.
In describing the functions, it is assumed that the receiver has already been
properly connected up by the specialist.
Should you want to undertake the connections yourself, please read the section:
“Connecting up and putting into operation“ beforehand.
Switching the unit on
• Press the mains switch (1) on the front of the unit.
After a little while four horizontal bars “– – – –“ appear on the LED display
indicating that the unit is switched on. Programme slot P001 appears.
• The
key on the remote control handset can be used to switch the unit
between normal operation and standby.
In standby mode a horizontal line appears in the LED display “ –“.
If you switch on the receiver from standby with the
key, is shown on the
LED display.
On switching on with the
standby key on the remote control, the last TV
programme slot that was selected is always tuned in.
If the receiver was switched off via the mains switch, the time setting is lost. On
switching on the time shows 1:00 (= Offset). After approximately 10 seconds the
time is updated automatically.
Switching the Navigator on
• Press the key on the remote control.
On the screen, the receiver shows the Navigator‘s first page:
The name and time are displayed in the header line. The remote control keys that
can be used for navigation are indicated in the footer line. If an open envelope is
displayed in the bottom right-hand corner, a new software version can be loaded
from the satellite (see “Initial settings“, “Settings“, “Software Update“).
A selected menu entry is displayed in white typeface on a dark background.