Filter
Top Products
4. Makesurethattheplastictubingisstillattachedfromtheairpressure
switchtotheportontheblowerhousing.MakesurethepJastic
tubingisnotfoldedanywherebetweenthepressureswitchand
theblowerhousing.
5. MakesuretheON/OFFswitchisintheOFFpositionandthatthe
outerharnessisconnectedfromtheblowercontrolboxtothe
connectoronthebottomsideofthegasvalve.
6. Iftheouterharnessisnotfactoryinstalled,makesuretheON/OFFswitch
isintheOFFpositionandthenconnecttheharnessfromtheblower
controlboxtotheconnectoronthebottomsideofthegasvalve.
waterhea_eristurned"OFF".
operation Ver_ proper operation after servicing
7. Do not plug in power cord until vent system is completely installed.
This power vent heater operates on 110o120 Vac, therefore a
grounded outlet must be within reach of the six (6) foot (! .8 m)
flexible power cord supplied with the unit (see Figure 1).The power
cord supplied may be used only where local codes permit, if local
codes do not permit the use of a flexible power supply cord:
a.) Make sure the unit is unplugged from wail outlet. Remove screws
and open panel on front of control box.
b.) Cut the flexible power cord, leaving enough to be able to make
connections and remove the strain relief fitting from box.
c.) Install suitable conduit fitting in side of enclosure and then follow
(d.) and (e.) below.
d.) Splice field wiring into existing wiring using code authorized method
(wire nuts, etc.).
e.) Be certain that neutral and live connections are not reversed when
making these connections.
f.) Close panel on the side of control box, make sure that access panel
is secured shut.
H
ON,OFF
BLOWER
vAcuur_ JUNCTIOK
Sg,'ITGH HOX
(EXNAJST STUD
Bb:_CKP,GE}
HIGHAIR BLOWE_
__ !TEMPERATURE MOTOR_ z
HEATER
CONTROL
PIN /
3ONK ECTOR L
FLAME SENSE ROD
N GND
BLOWER ASSEMB_
MOUNFING SCREW
(JACKETFANK GROUND
CONNECTION)
6WIRE
CABLEASSEMBLY
You must provide all wiring of the proper size outside of the water heater, You must obey local codes and electric
utility requirements when you install this wiring
This appliance must be electrically grounded in accordance with local codes, or inthe absence of local codes, with the
National Electrical Code NFPA 70 (current edition).
Note: if any of the origieal wire as supplied with the appliance mast be replaced, it must be replaced with
105°0 wire or its equivalent.
16