Filter
Top Products
ENGLISH 55
CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals
(ACC)
(BATT)
(GND)
10 A fuse
Connect to the vehicle’s reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle’s parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Purple with white stripe
(Reverse sensor wire)
Connect the antenna
cord to the antenna
terminal.
Page57
Page57
3
Connect to the vehicle’s steering remote harness.
Contact your Kenwood dealer for details.
Page57
USB terminal:
Pages56 – 57
Pages56 – 57
Ignition key switch
Fuse box
Battery
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
To car chassis
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
* If no connections are made, do not let the cable come out from the
tab.
*
6