Filter
Top Products
22 English
Bluetooth Setup
Registering Bluetooth Device
(Pairing)
Registering from Bluetooth devices
1 Press SRC to turn on the power.
2 Start registering this unit by operating
the Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit (pairing). Select “KCA-
BT300” or “KCA-BT200” from the list of
connected units.
3 Input the PIN code (“0000”) in the
Bluetooth device.
Check that registration is complete on
the Bluetooth device. PIN code is set to
“0000” as the default. You can change this
code. Refer to [PIN CODE EDIT] under
<Bluetooth Setup> (page 24).
4 By operating the Bluetooth device, start
hands-free connection.
Registering from this unit
1 Press and hold the volume knob to enter
Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [DEVICE
SEARCH], then press to enter.
5 Press the volume knob to search for the
Bluetooth device.
When search is completed, “FINISHED” is
displayed.
6 Turn the volume knob to select a
Bluetooth device name, press to confirm.
7 “PAIRING” is displayed (KCA-BT300 only)
If “PAIRING OK” is displayed, proceed to
step 10.
If “PIN CODE NG” is displayed, proceed to
steps 8.
8 Input the PIN code
■
Turn the volume knob to select the
number.
■
To move to the next digit, press ¢.
■
To delete the last digit, press 4.
9 Press the volume knob to transmit the
PIN code.
If “PAIRING OK” is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
Registering Special Bluetooth device.
When “CONFIRM PHONE” is displayed,
confirm connection with a cell-phone
operation.
10 Hold to finish the procedure.
■
To exit Bluetooth mode, press SRC.
■
If there are 5 or more Bluetooth devices
registered, you cannot register a new
Bluetooth device.
Registering Special Bluetooth device
1 Press and hold the volume knob to enter
Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [S-DVC
SELECT], then press to enter.
5 Turn the volume knob to select a device
name, the press to confirm.
6 Go through the procedure step 4
of <Registering from this unit> and
complete the registration (pairing).
■
If the device name is not in the list, select
“OTHER PHONE”.
Preparation : Only with the optional accessory KCA-BT300 or KCA-BT200 connected.