Filter
Top Products
14
English
All Modes
• VOL. buttons
Press the u button to turn the volume up.
Press the d button to turn the volume down.
• TUNER button
Selects the tuner mode. Pressing this button again selects the
standby mode.
• CD button
Selects the CD mode.
• CD•MD CH button
Selects the disc changer mode. When two disc changers are
connected to the unit, the disc changer mode will be split into
disc changer mode 1 and disc changer mode 2, and each press
Tuner Mode
• Number/ letter entry buttons
Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the
frequency of the station.
Use to enter letters (alphabetical) during station name preset.
• TUNE buttons
Press the TUNE
– button to make decreasing seeks (using the
preset tuning mode).
Press the TUNE+ button to make increasing seeks (using the
preset tuning mode).
Use to move the cursor left or right during station name input.
• AM/FM button
Press the AM button to select the AM band.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
During station name input, selects digits and symbols.
• DIRECT/OK button
Selects the direct access tuning mode, used to input
frequencies directly. Press this button again to cancel the mode
while it is operating.
During station name input, stores the already input data in
memory and ends the input mode.
During Station name preset play mode, selects station.
• DNPP button
Enters and cancels the Station Name Preset Play mode.
Basic operations of remote (See page11)
Do not set the remote on hot places such as above the
dashboard.
Replacing the Lithium Battery:
Use one lithium battery (CR2025).
Remove the case following the instructions as illustrated.
Insert the battery with the
+ and – poles aligned properly,
following the illustration inside the case.
Store unused lithium batteries out of the reach of children.
Contact a doctor immediately if the battery is accidentally
swallowed.
2WARNING
2CAUTION
2
1
To open
1 Keep on slide
2 Pull out.
of this button switches between them.
The KCA-S200, which is sold separately, must be used when two
disc changer units are connected.
When the KDC-C810 is the directly connected disc changer (disc
changer 1), two units may be controlled even without the KCA-
S200.
NOTE