Filter
Top Products
Function of the KDC-X915/KDC-X815
“Bass EXT” : Switch the Bass Extend mode on/off.
Setting values: ON / OFF
(When the bass extend mode is set to on, low
frequency response is extended by 20%.)
This mode is available only when the Sound coordinate system is
on. (page 38)
NOTE
Function of the KDC-X915/KDC-X815
“Bass Q” : Adjust the Bass quality factor.
Setting values: 1.00 / 1.25 / 1.50 / 2.00
This mode is available only when the Sound coordinate system is
on. (page 38)
NOTE
“Bass” : Adjust the bass level.
Setting values: - 8 – + 8
Function of the KDC-X915/KDC-X815
“Bass Frq” : Adjust the center frequency of the bass.
Setting values: 60 / 70 / 80 / 100 (Only when the bass quality
factor is set to 1.0, 1.25 or 1.5) / 150 (Only when the bass
quality factor is set to 2.0) Hz
This mode is available only when the Sound coordinate system is
on. (page 38)
NOTE
"Kex"/"ec4" : Recalling the kenwood preset sound setting
Press the preset buttons (#1-6).
Settings: #1;Flat, #2;Rock, #3;Top40, #4;Jazz, #5;Easy,
#6;Scan of #1-5
• This mode is available only when the Sound coordinate system
is on. (page 38)
• You can call the following settings with this function; bass
center frequency, bass level, bass quality factor, bass
extension, treble center frequency, and treble level setting.
Their setting values are different depending on the setting of
the mobile preset plan mode(KDC-9015 only).
NOTE
Adjust various parameters of sound quality.
Press the AUD button to enter the control mode.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.
Source tone memory
Each source (CD, FM, AM and disc changer ) has its own
memory in which to store the bass, treble and N-F level settings.
The settings made for a particular source are recalled
automatically whenever you use that source ( for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
Press the AUD button to end the control mode.
4
3
NOTE
2
1
Audio Control Setting
— 9 —
KDC-X915_U.S_r4 00.12.26 3:53 PM Page 9