Filter
Top Products
Adjustment Item
Display Range
Bass Center Frequency* “Bass FRQ”
60/70/80/100 or 150 Hz
Bass level
L “Bass”
-8-+8
Bass Q Factor*
“Bass Q”
1.00/1.25/1.50/2.00
Bass Extend*
“Bass EXT”
ON/OFF
Middle Center
“MID FRQ”
0.5/l .0/l .5/2.0 kHz
Frequency*
Middle level
“MID” -8-+8
Middle Q Factor*
“Middle Q”
1.0/2.0
Treble Center Frequency* “TRE FRO”
10.0/12.5/15.0/17.5 kHz
Treble level
“TRE”
-8-+8
Balance
“Balance”
Left 15 - Right 15
Fader
“Fader”
Rear 15 - Front 15
NonFadIng level*
“N F Level”
-15-+I5
Front Hugh Pass Filter*
“HPF Front” Through/40/60/80/i 001
120/150/180/220 Hz
Rear High Pass Filter*
“HPF Rear” Through/40/60/80/i OO/
120/150/180/220 Hz
Non-Fading
“LPF NF”
50/80/l 20/Through Hz
Low Pass Filter*
Non-Fading Phase*
“NF Phase” Normal (O”)/Reverse
(180")
Volume offset
“Volume Offset” -8 - *O
l
According to the Bass 0 Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass 0 Factor
Bass Center Frequency
1.00/l .25/l .50
60/70/80/l 00
2.00
60/70/80/l 50
l
When the bass extend is set to ON, low frequency response IS
extended by 20%.
l
Volume offset: Each source’s volume can be set as a difference
from the basic volume.
l
* :Function of the KDGX659 / KDGX559
5 Exit Audio Control mode
Press the [AUDI button.
Function ofthe KDC-MPSlS/KDC-71:
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1
Enter Standby
Press the [SRCI button.
Select the “ALL OFF” display.
2 Enter Speaker Setting mode
Press the IQ] button.
“Speaker Setting” is displayed.
3 Select the Speaker type
Press the
[I-I
or
[WI
button.
Each time the button is pressed the setting switches as shown
below.
Speaker type
Display
OFF
“OFF”
For 5 & 4 in. speaker
“5/4 inch”
For 6 & 6x9 in. speaker
For the OEM speaker
“6+9/6 inch”
“O.E.M.”
4 Exit Speaker Setting mode
Press the
[Ql
button.
-ll-