Kenwood KDC-722 Car Stereo System User Manual


 
1st section
[2] button
Adjustment Item Display Range
Bass Center
Frequency**
"Bass F" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor** "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend**
"Bass EXT" ON/OFF
[3] button
Adjustment Item Display Range
Middle Center
Frequency**
"MID F" 0.5/1.0/1.5/2.0 kHz
Middle level "Middle" –8 — +8
Middle Q Factor** "Middle Q" 1.0/2.0
5 Select the Audio Control item for adjustment
Press the [2] — [5] button.
Each time the [2] [5] button is pressed the adjustable audio
items are switched among ranges of all stage section's tables on
the following pages.
6 Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
7 Exit Audio Control mode
Press the [RTN] button.
The loudness setting can also be adjusted by pressing the [4]
button.
•*This mode is available only when <Non-fading Output> (page 17)
is ON.
1 Select the source for adjustment
Press the [SRC] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "AUD" is displayed above the
[2] button.
Refer to <Notes on Multi-function Key System> (page 8).
3 Enter Audio Control mode
Press the [2] ("AUD") button.
4 Select the Adjustment item section
Press the [NEXT] button.
Repeatedly press the button until the desired Adjustment item is
displayed above the [2] [5] button.
1st section
Adjustment Item Button Display
Bass [2] "BASS"
Middle [3] "MID"
Treble [4] "TRE"
Balance & Fader [5] "BL/F"
2nd section
Adjustment Item Button Display
High Pass Filter [2] "HPF"
Low Pass Filter* [3] "LPF"
Loudness [4] "LOUD"
Non-Fading* [5] "N-F"
3rd section
Adjustment Item Button Display
Volume offset [2] "VOFF"
Audio Control
General features
— 12 —
English
KDC-MP822_U.S 02.12.11 11:23 AM Page 12