Filter
Top Products
English
— 42 —
Removing the UnitInstallation (Japanese-cars)
Catch
Lock
Accessory2
Removal tool
■ Removing the hard rubber frame
2 When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1 Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
8mm
5mm
5mm
8mm
For Nissan Car
Accessory4
for Toyota car
Accessory3
for Nissan car
For Toyota Car
Damage to the unit will result from using screws other than
those provided.
Factory-installed
Radio Bracket
After aligning the factory-installed radio
bracket, tighten the screws.
KDC-MP822_U.S 02.12.11 11:23 AM Page 42