Filter
Top Products
14
|
English
General features
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
4 Exit Speaker Setting mode
Press the [VOL] knob.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass
Filter*
1,3
"HPF" Through/40*
5
/60*
5
/80/100/
120/150/180/220*
5
Hz
Rear High Pass Filter*
1,3
"HPR" Through/40*
5
/60*
5
/80/100/
120/150/180/220*
5
Hz
Low Pass Filter*
1,2,3
"LPF" 50*
5
/60/80/100*
5
/120/
Through Hz
Subwoofer Phase*
1,2,3,4
"PHAS" Reverse (180°)/ Normal (0°)
Volume offset "V-OFF" –8 — ±0
Loudness "LOUD" OFF/ON
Dual Zone System*
1
"2ZON" OFF/ON
• Volume offset: Sets each source’s volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *
1
Function of KDC-X590/MP632U.
• *
2
You can control this item when <Switching preout>
(page 30) is set to "SWPRE SW". (KDC-MP632U only)
• *
2
You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
• *
3
You can control this item when "2ZON" of <Audio
Setup> (page 14) is set to "OFF".
• *
4
You can control this item when Low Pass Filter is not
set to Through.
• *
5
KDC-X590 only
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 30).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 12).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Internal auxiliary input (KDC-MP632U only)
- Option CA-C1AX/ CA-C2AX (KDC-X590 only)
5 Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.