Filter
Top Products
English
|
27
2 Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
Adjustment Item Button Display
Search down in category [2] "CS–"
Search up in category [3] "CS+"
Search down for channel in selected category [4] "CH–"
Search up for channel in selected category [5] "CH+"
•
You cannot operate this unit until all the Category
information is acquired.
Function of remote
Direct Access Tuning
Entering the channel and tuning.
1 Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote.
2 Enter the channel
Press the number buttons.
3 Do Channel Search
Press the [4] or [¢] button.
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• You can set up to Channel number 223.
• If there is no signal in the input Channel, "NO CH"
appears.
• If you cannot receive any signal in the input Channel
due to a bad condition on radio wave or another
problem, "Acquiring Signal" appears.
Selecting the Preset Band
Press the [FM] button.
Each time the button is pressed the preset band
switches between the SR1, SR2, SR3 and SR4.
Channel Preset Memory
Putting the channel in the memory.
1 Select the preset band
Press the [FM] button.
2 Select the channel to put in the memory
Press the [4] or [¢] button.
3 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until the function
item is not displayed above the [2] — [5] button.
Refer to 'Notes on Multi-function Key System'
(page 10).
4 Put the channel in the memory
Press the desired [1] — [6] button for at least
2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the
memory on each [1] — [6] button.
• Only the channel number is stored. Category
information is not stored.
Preset Tuning
Calling up the channels in the memory.
1 Select the preset band
Press the [FM] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until the function
item is not displayed above the [2] — [5] button.
Refer to 'Notes on Multi-function Key System'
(page 10).
3 Call up the channel
Press the desired [1] — [6] button.