Filter
Top Products
English
31
Refer to the section “Removing the Hard Rubber
Frame” and then remove the hard rubber frame.
Remove the Hex-head screw (Accessory 9) with
integral washer (M4×8) on the back panel.
Insert the two removal tools deeply into the slots on
each side, as shown.
Be careful to avoid injury from the catch pins on the
removal tool.
Lower the removal tool toward the bottom, and pull
out the unit halfway whilst pressing towards the
inside.
Pull the unit all the way out with your hands, being
careful not to drop it.
5
4
2 CAUTION
3
2
1
Removing Unit
Removing the Hard Rubber Frame
■
Engage the catch pins on the removal tool and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
When the lower level is removed, remove the upper
two locations.
The frame can be removed from the top side in the
same manner.
NOTE
21
Removing the Unit
■
Catch
Lock
Accessory 4
Catch facing up
U
P
7
U
P
On cars where there is no compartment in the centre for installing a car audio unit:
Use the spacer (Accessory 0) to affix the centre unit sleeve and the sleeve attached to the main unit in such a way
that they are correctly aligned both depthwise and horizontally.
On cars lacking a centre
compartment
Accessory 0