Filter
Top Products
R-SG7/DP-SG7/X-SG7 (EN)
19
Preparation section
Basic section
Application section
Knowledge sections
Hearing sound
Listening through headphones
1 Insert the headphone plug into the phones jack.
÷ Headphones with a stereo mini plug can be connected.
÷ The sounds from all speakers are cut off.
Power Switch Standby
When this system is in standby condition (time display
for the R-SG7, STANDBY indication for DP-SG7, standby
indicator lit for X-SG7), a slight current flows for memory
protection.
At this time also, the remote control can be used for
power ON.
÷ Press again to resume the original volume.
÷ This is also cancelled when the volume is adjusted.
2 Adjust the volume.*(step 3)
Remote control unit
Blinks
÷ When the TUNER input is selected, it is available only
when the volume is set to 0.
When CD has been selected.
AUTO POWER SAVE function
When the power is ON and neither recording nor
playback is executed for 30 minutes or more, the
power is switched off automatically by this func-
tion. This function can be made active or not active
by the following operation.
Each press switches the modes as follows.
1APS ON..... Auto power save is used.
2APS OFF.... Auto power save is not used.
Press when the power is OFF.
Volume display
R-SG7
R-SG7
R-SG7
Muting the sound temporarily
(Remote control unit only)
MUTE
phones
pure
MUTE
CD
VOL 2)
Bass and treble compensation
(N.B.: Natural Bass circuit)
Lights
R-SG7
The indication changes each time this key is pressed.
1 NB ON1 ...
Compensation of highest and lowest fre-
quencies according to the current volume
level (Effective during low-level listening).
2 NB ON2 .... Compensation of lowest frequencies
according to the current volume level.
3 TONE FLAT (TONE) Variation of tone.
N.B./tone
NB
enter
volume
control
pure
A
∞ ∞
down up
1 Press the N.B./tone key so that "TONE FLAT"
("TONE") is displayed.
2 Press the ENTER key
while"TONE FLAT"
("TONE") is displayed.
The indication changes each time this key is pressed.
1 BASS.......Adjusts the lowest fre-
quencies.
2 TREBLE ... Adjusts the highest fre-
quencies.
÷ Use the VOLUME control to adjust BASS or TREBLE
in the range between -10 and +10. ("TONE FLAT" is
displayed when both the BASS and TREBLE values
are set to +/-0. "TONE" is displayed when any of them
is adjusted to a value other than 0.)
Adjust the “TONE”