Filter
Top Products
R-SG7/DP-SG7/X-SG7 (EN)
23
Preparation section
Basic section
Application section
Knowledge sections
Hearing sound
Selection of DOLBY NR
(Noise Reduction)
To stop playback
Selection of reverse mode
To pause the tape
÷ Set the tape correctly as shown in the figure. Wrong tape
setting can cause trouble.
÷ Normal (TYPE I), high (TYPE II), or metal (TYPE IV) tape
selection is set automatically.
÷ Remove tape slack before loading.
÷ Press the 2 or 3 key to restart playback.
÷ Select the Dolby NR mode according to the recording
condition of the tape.
Each press switches the modes as follows.
1 “B” is lit ... Dolby B NR is used.
2 “C” is lit ... Dolby C NR is used.
3 “B” and “C” not lit ... Dolby NR is not used.
Transport direction indicators
The 2 and 3 indicators indicate the current direc-
tion in which the tape advances when playback or
recording is started automatically by the easy op-
eration function, etc. This direction is the direction
stored in memory when the tape was last stopped.
(To change the direction, press the key for the de-
sired playback direction, and then press the 7 key.)
The Dolby NR system minimizes the hiss noise
heard when playing tape.
Each press switches the modes as follows.
1 “””lit......Both sides are played. (The tape
stops after recording onto both
sides.)
2 Goes off .... Only one side is played back (re-
corded), and then the tape stops.
To wind tape at high speed
÷ Press the 7 key to stop fast winding.
To fast wind in
direction \
To fast wind in
direction |
Transport direction indicators
7
1
¡
Dolby NR
BC
2
3
÷ The tape direction lights red.
8
rev. mode
∏
Since longer tape than 100 minutes cassette tape
is very thin, the tape could adhere to the pinch
roller or be easily cut. It is recommended that
these tapes not be used with this unit to prevent
possible damage.
NoteNote
Note