Filter
Top Products
6
BASIC OPERATIONS
Switching power on/ oFF
Press to switch the transceiver ON.
• A beep sounds and the display illuminates. If the Power-on tone select is set to OFF,
the beep will not sound.
•
If the Transceiver Password function is programmed, “PASSWORD” will appear on the
display. Refer to “Transceiver Password”, on page 6.
Press again to switch the transceiver OFF.
n Transceiver Password
To enter the password:
1 Press
/ to select a digit.
• When using a keypad, simply enter the password digits and proceed to step 4.
2 Press C> to accept the entered digit and move to the next digit.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
3 Repeat steps 1 and 2 to enter the entire password.
4 Press S or
to conrm the password.
• If you enter an incorrect password, the transceiver remains locked.
AdjuSting the Volume
Press the Volume Up key to increase the volume. Press the Volume Down key
to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to
listen to background noise while adjusting the volume level.
Selecting A Zone And chAnnel/group id
Select the desired zone and channel/group ID using the keys programmed as
Zone Up/ Zone Down and CH/GID Up/ CH/GID Down.
• You can program names for zones and channels/group IDs with up to 10
characters.
n Home Channel/Group ID
Y
ou can select your Home channel/group ID by pressing Home CH/GID.
Press the key a second time to return to your previous channel/group ID.
n Direct Channel/Group ID
Y
ou can quickly select a commonly used channel/group ID by pressing Direct
CH/GID 1 ~ Direct CH/GID 4. Press the same key a second time to return to
your previous channel/group ID (if the key assignment Direct CH/GID return is
congured as “Enabled”).