Filter
Top Products
13
4 Press S to enter Status mode.
5 Press
/ (if the key assignment list selection is congured as “Enabled”)
or <B/C> to select the status ID you want to transmit.
• You can also enter the status ID directly by using the keypad.
6 Press the PTT switch or n to initiate the status call.
n Receiving
When a status call is received, the
icon will ash and the calling ID or
text message will appear on the display. Press any key to return to normal
operation.
n Reviewing Messages in the Stack
1 Press and hold the key programmed as Stack, Selcall, Status, or
Selcall + Status.
2 Press
/ (if the key assignment list selection is congured as “Enabled”)
or <B/C> to select your desired message.
3 Press
to return to normal operation.
Short/long meSSAgeS
To send and receive short or long messages, use the Selcall + Short Message
or Short Message functions, or connect the transceiver to a PC. (Ask your
dealer for details.)
• Short messages can contain a maximum of 48 characters. Received short messages
are displayed the same as Status messages and are stored in the same stack memory.
A
combined maximum of 15 Status calls and short messages can be stored in the stack
memory.
•
Long messages can contain a maximum of 4096 characters and can only be viewed via
a PC.
gpS report
If a GPS unit (NMEA-0183 format) is installed on your transceiver, you can press
the key programmed as Send the GPS data to send your location data.
ADVANCED OPERATIONS
emergency cAllS
If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time
you must hold the Emergency key will vary.