Filter
Top Products
11 GB/IE
1 x Stripping tongs or cable stripping knife
1 x Screwdriver
1 x SW 8 spanner (jaw size 8 mm)
1 x Ballpoint pen
For the connection of an aerial installed in the
vehicle you may require :
1 x Aerial adapters (in accordance with the technical
data of the aerial)
For the connection of an amplifier you will
require:
2 x Cinch connection cables
(insulation and plug: white / red)
L Installation
L Removing the control panel from
the car radio
• Avoid hard contact with the display window 9.
• Press the “Open” button 4and allow the control
panel 1to reach the horizontal position.
• Push the control panel 1slightly to the left
and pull it forwards.
• Store the control panel in the plastic box (see
also the illustration in the section „Attaching
the Control Panel“).
L Installing the DIN assembly bracket
in the vehicle‘s instrument panel
• Remove all packing material from the device.
• Unscrew the safety transport screws gpcom-
pletely from the metal housing du(see Fig. E)
and carefully release the plastic frame 2from
the front of the device ct.
• Release the attachment points by slightly raising
the upper frame edge and pulling it carefully
towards the front.
• Push the two installation keys irbetween the
metal housing duand the preassembled DIN as-
sembly bracket iq until they clearly lock in place.
Ensure that the convex side faces outwards in
each case. Store the installation keys ircarefully
for future use.
• Remove the DIN assembly bracket iqand place
it flush in the DIN assembly cut-out of the vehi-
cle‘s instrument panel.
• Secure the DIN assembly bracket iqagainst
removal. Bend approximately ten tin dog points
on both the upper and lower side of the DIN
assembly bracket iqfrom the inside towards the
outside. Please ensure that the DIN assembly
bracket iqis installed flush in the DIN assembly
cut-out.
• Attached the plastic frame 2completely to the
front of the device ct.
L Connecting to the loudspeakers
of the vehicle
Tip! Use an ISO plug.
• Guide the connection cables of the loudspeakers
mounted in the vehicle carefully out of the front
of the DIN assembly bracket iq.
• Establish the connection between the connection
cables of the ISO plug and the connection cables
of the loudspeakers fitted to the vehicle with
the help of biscuit connectors, ensuring that
the connections in the biscuit connectors do
not cause any short circuits and that the fixing
screws are firmly tightened.
• Connect the lead of the plug-in emto the lead (+)
for the rear right loudspeaker.
• Connect the lead of the plug-in ento the lead (-)
for the rear right loudspeaker.
• Connect the lead of the plug-in eoto the lead (+)
for the front right loudspeaker.
• Connect the lead of the plug-in epto the lead (-)
for the front right loudspeaker.
• Connect the lead of the plug-in eqto the lead (+)
for the front left loudspeaker.
• Connect the lead of the plug-in erto the lead (-)
for the front left loudspeaker.
• Connect the lead of the plug-in esto the lead (+)
for the rear left loudspeaker.
• Connect the lead of the plug-in etto the lead (-)
for the rear left loudspeaker.
Preparation / Installation
KH2391_Content_UK.indd 11 05.09.2006 14:49:11 Uhr