Filter
Top Products
33
206-4257
Custom Master TV Setup (Cont.)
Custom Master TV Setup Procedure
1. Turn ON the TV.
If the EZ-Manager Wizard appears on the screen when you turn ON
the TV, use the arrow keys on the Installer Remote to select Exit from
the Welcome screen and press OK. In the conrmation pop-up window,
select OK, and then press OK once more on the Installer Remote to
exit the wizard.
2. Set Installer Menu items.
This step provides specic instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 22 to 31 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 22 for further information).
The next step depends on whether the EZ-Manager Wizard
appeared when you turned ON the TV:
• If the wizard did appear, the TV is in a factory default state, and
you can proceed to set Installer Menu items. Go to step (c).
• If the wizard did not appear, go to step (b).
b) Set Installer Menu item 117 FACT DEFAULT to 1 and press OK
on the Installer Remote.
This clears all Installer Menu custom settings, channel lineup, etc.
and restores the factory default settings. The value will change
back to 0 after the commercial controller (PTC) has been restored
to factory default condition. This step ensures that the TV Channel
Memory will be the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0. • HRC: Set to 2.
• CATV: Set to 1 (default). • IRC: Set to 3.
d) Set any other Installer Menu items that affect your TV programming
network to the required conguration. For example, enable/disable
Aux inputs, set a Start Channel, etc.
You may also congure Pro:Centric settings in the IP Environment
Menu (accessible from the Installer Menu). See “IP Environment
Setup” on pages 45 to 48 for further information.
e) After you have adjusted all Installer Menu item and/or IP
Environment settings as required, press OK once on the Installer
Remote to save your changes; then, press OK again to exit the
menu.
(Continued on next page)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the values for these
Installer Menu items, as required.
117 FACT DEFAULT 000
003 BAND/AFC 001
xxLY570H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D27D
PTC V1.00.028 CPU V3.09.00