Filter
Top Products
49
206-4257
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Master TV Setup and TV cloning procedures are
complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
port on the TV’s rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio connectors, as
applicable, for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
093 RJP AVAILABLE 001
ANTENNA/
CABLE IN
RGB IN (PC)
TV-LINK CFG
SPEAKER OUT
LINE OUT
SERVICE ONLY
RJP
..........
VIDEO
L/MONO-AUDIO-R
AV IN / AUDIO IN (RGB DVI)
L R
OPTICAL
AUDIO OUT
LAN
GAME CONTROL
/ MPI
1
IN
RESET
RESET
UPDATE
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP
Connect RJ-45
Control cable from
RJP cable bundle.
RGB IN (PC)
Connect RGB connector
from RJP cable bundle
(legacy RJP only).
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)