Filter
Top Products
37
206-4257
(Continued on next page)
Cloning Procedures (Cont.)
(Continued from previous page)
• If the TLX le contains an FTG Channel Map that was created in the FTG File Manager, all
physical RF channels and Aux inpupts have been assigned logical channel numbers. When
you Teach the FTG Channel Map to the Target TV(s), you will have the option to select logical
or physical channel tuning. If you select physical channel tuning, the physical RF channels and
Aux inputs in the FTG Channel Map will remain in logical order.
• If the Target TV EBL is already in FTG Mode, you cannot use this procedure to make changes
to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described in Reference section, “FTG Mode via EBL (Local Conguration),” or an
FMA head end device to recongure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU, refer
to Reference section, “Restoring Factory Defaults on the TV(s),” for further information before
proceeding.
• If the Target TV is currently in Pass-through Mode and you intend to use the TV Zoning feature
(i.e., if a TV Zone # was set in the Master TV before a Learning process was initiated or if a Zone
has been assigned to the Installer Menu prole in the FTG File Manager), make sure to assign
the appropriate TV Zone # as described in Reference section, “Using the TV Zoning Feature,”
BEFORE continuing with the procedure below.
• If the TLX le was created in the FTG File Manager, it may contain multiple zoned FTG Installer
Menu proles for different TV models. Make sure it includes the appropriate Installer Menu
prole(s) for the Target TV(s) before Teaching.
Caution: Do not unplug the TV power cord or remove/disconnect the USB memory
device while Teaching, as doing so may cause the TV to malfunction or harm the
USB device, respectively.
Teach Conguration to Target TV
1. Turn ON the Target TV.
Note: If the EZ-Manager Wizard appears on the screen when you turn ON the Target TV, you
can complete the Teaching process via the wizard. To continue with this procedure, exit the
wizard: Use the arrow keys on the Installer Remote to select Exit from the Welcome screen and
press OK. In the conrmation pop-up window, select OK, and then press OK once more on the
Installer Remote. Then, go to step 3.
2. If the TLX le you are using for Teaching contains an Installer Menu prole with a Zone
assignment, either from the Master TV Setup or when congured in the FTG File Manager,
make sure to assign the same Zone designation in the Target TV at this time. Refer to Reference
section, “Using the TV Zoning Feature,” for further information.
Note: In order for the proper location-specic TV Zone prole data to be applied,
the Zone designation must be assigned in the Target TV(s) BEFORE Teaching is
performed.
3. Insert the USB memory device with the TLX le into the USB port on the Target TV.
4. Press MENU SETTINGS on the Installer Remote to display the TV setup menus (TV is in
Pass-through Mode) or the Function Menu (TV is already in FTG Mode).