Filter
Top Products
10
Preparation
This section explains how to set up your Plaza HD•T2
to receive Freeview channels.
To receive Freeview, you must connect your Plaza HD•T2 receiver
to an appropriate TV aerial that has been correctly installed. If
your aerial is unable to provide adequate signal, it may need to be
realigned. Please consult a professional.
CONNECTING YOUR RECEIVER
Place your Plaza HD•T2 receiver on a firm, level surface close to the
television, a mains electricity socket, and the cable from the aerial.
(See Appendix A – Safety.)
2
Connect the cable from your aerial to the ANT IN socket at the
back of the Plaza HD•T2. If you also want to use your television’s
internal tuner, you can optionally connect a cable from the ANT
OUT socket at the back of the Plaza HD•T2 to the appropriate
input on your television. Please note that to conserve energy, by
default this output is disabled when the Plaza HD•T2 is in standby.
You can enable it in the System section of the Setup menu (please
see page 29).
THE AERIAL