Filter
Top Products
6
Top and Front Panel Features
Power Button
Turn the monitor off or on by pressing the power
button. In the ON state, the LED above the power
button will illuminate green.
Menu Navigation Buttons
Use the Menu, ↑, ↓, and Select buttons to display
and navigate the on-screen menu (See Main Menu
and Navigation – Page 9).
User-Definable Function Buttons
Two user-definable function buttons can be used for
direct access to various settings. Functions are
assigned using the on-screen menu (See User-
Definable Function Buttons – Page 15).
RotoMenu™ Knob
The RotoMenu™ knob is alternate means of
accessing and navigating the main menu, using only
a single control.
Image Adjustment Knobs
Use the image adjustment knobs to adjust color
saturation, brightness and contrast of the image.
The status of each image adjustment parameter is
shown on the bottom left of the screen, with values
ranging from 0 to 100. Pressing each knob resets
the corresponding adjustment to its default setting
(50).
LED Tally
Three LED tally lights (yellow, red, green) are
available above the screen. Each tally light can be
controlled from a variety of sources (See Tally
Source – Page 21).
Top View
Front View
19
On-Screen Menu (continued)
IMD CONFIGURATION SUBMENU
■
Overview
The V-R201-IMD-TE features an In-Monitor Display (IMD) with the ability to display on-screen text and tally in three
colors. IMD text, color, and alignment can be assigned to each screen locally using menu options (see below).
Alternately, IMD text and tally can be remotely controlled via the RS-422/485 serial interface using several industry-
standard protocols, including TSL and Image Video. Multiple V-R201-IMD-TE monitors can be looped together and
each addressed individually via the protocol. All menu features of the V-R201-IMD-TE can also be controlled via the
Marshall Network Controller box and Marshall protocol. (Contact Marshall Electronics for additional information).
Use the IMD Configuration submenu to configure various IMD parameters as described below.
■
IMD Protocol
Use the IMD Protocol menu option to choose the protocol with which the V-R201-IMD-TE receives remote commands.
Currently, four protocols are available. Contact Marshall Electronics for the latest protocol compatibility.
Image Video
Use the Image Video protocol setting when controlling the IMD from an Image Video tally controller (e.g. TSI-
1000) or other controlling device which utilizes the Image Video protocol. The IMD #, IMD Name(S/N), and Baud
Rate parameters must be set for each screen in conjunction with the controlling device.
TSL v4.0
Use the TSL v4.0 protocol setting when controlling the IMD from a TSL tally controller, or other controlling device
which utilizes the TSL v4.0 protocol. The IMD # must be set for each screen in conjunction with the controlling
device.
Marshall
Use the Marshall protocol setting when controlling the V-R201-IMD-TE using the Marshall Network Controller box.
This protocol allows remote control of all features on the V-R201-IMD-TE, including marker setup, video
configuration, system configuration, and image adjustments (brightness, contrast, etc.). The IMD #, IMD Group #,
and Baud Rate parameters must be set in conjunction with the Network Controller Box.
Marshall-IV
This protocol setting accepts Image Video commands via the Marshall protocol, for use when an Image Video
controller is connected to the Marshall Network Controller box.
IMD Configuration Submenu